NSK Primado2 Manual De Operación página 14

3-3 Connection of the Motor
By matching the mark on the Motor Cord Plug and the mark
or B) at the front of the Control Unit, plug the Motor into the Connector all the way.
● There are two Motor Connectors. By connecting two Motors to the two
CAUTION
connectors, you can select the one you want to use by the Motor Select
Button (however, both Motors cannot be operated simultaneously). The
selected Motor can be confirmed in the Main Panel.
● Do not pull the Motor Cord to disconnect the Motor.
To disconnect the Motor, hold the Motor Cord Plug and pull it out with a straight movement.
● Whenever you use two Motor Connectors alternately, be sure to confirm which Motor is under operation.
CAUTION
● Do not connect anything else other than the Motor exclusively used for this system. Otherwise, the Motor Connector
might become deformed or failure could occur.
● If the Motor Cord cannot be connected to the Control Unit easily, do not insist. Deformation or cracks might occur. A
foreign substance might be obstructing the connection or the connection portion might be deformed. Contact your
dealer.
● Whenever connecting/disconnecting the Motor with Hand Control and Wire Pin Driver, be sure to switch OFF the Safety
Lock.
● When connecting/disconnecting the Motor, do not turn the Motor Cord Plug. Otherwise, the inside pins might become
damaged, leading to failure.
● Prevent the Motor Cord Plug from falling onto the floor or receiving a strong impact; otherwise, deformation might occur
and it might become impossible to establish a proper connection.
● Do not connect/disconnect the Motor Cord with wet hands; otherwise, electric shock might occur.
● Be sure to hold the Motor Cord Plug when disconnecting the Motor from the Control Unit to prevent failure caused by
breaking wires.
3-4 Mounting of the Attachment
● Whenever mounting/removing the Attachment, be sure to switch OFF the Safety Lock of the Wire Pin Driver / Motor with
CAUTION
Hand Control.
● Prior to mounting/removing the Attachment, remove the Cutting Accessories. Otherwise, injury might occur.
● After mounting the Attachment, confirm that the Attachment and Motor are connected properly.
P200-HMH and P200-HMH-HS Handpieces
<Mounting>
1) Push the Attachment into the Motor straight.
2) Turn the Attachment rightward or leftward so that the Alignment Pin of the Motor
matches the hole of the Attachment with a clicking sound to connect firmly.
<Removing>
Pull out the Attachment from the Motor straight.
P200-SMH-S, P200-SMH and P200-SMH-HS Handpieces
<Mounting>
1) Push the Attachment into the Motor straight.
2) Align the "
" Symbol of the Attachment and "
the Attachment in until it clicks to connect firmly.
<Removing>
Pull out the Attachment from the Motor straight.
on the Motor Connector (A
" Symbol of the Motor, then push
Mark Mark
Mark Mark
Motor Cord Plug Motor Cord Plug
Fig. 4
Alignment Alignment Alignment Pin Alignment Pin
Hole Hole
Attachment Attachment Motor Motor
Fig. 5
Symbol Symbol Symbol Symbol
Attachment Attachment Motor Motor
Fig. 6
13