Thermostatic Adjustement; Temperature Limitation; Callibrating Thermostat - Hansgrohe PuraVida 15771 Serie Modo De Empleo / Instrucciones De Montoje

Thermostatic Adjustment

Temperature Limitation

The temperature is limited by the safety stop to 40°C.
If a higher temperature is required, it is possible to
over ride the safety stop by depressing the safety
button.
NB. It is recommended that for private domestic
use the maximum mixed water temperature be set
at the following factory set values:
Shower Mixer 43°C
Bath/Shower 46°C
Temperatures can be set by following the procedures
under „Setting thermostat to a maximum
temperature". This ensures that after correct
installation the outlet temperature of the water can
never exceed 43°C.
To guarantee a smooth running of the thermostatic
element, it is necessary from time to time to turn
the thermostat from total hot to total cold. The
thermostatic mixer valve should be checked annually
by a qualified person to ensure correct operation.
The mixer is fitted with check valves (page 15 pos.
9) and filters on the thermostatic element (page 15
pos 2). If the water flow drops the filters need to be
cleaned. Proceed as follows:
1. Remove the handle end cap, undo the screw
and pull off the handle and safety set disk.
2. Remove the faceplate, the sleeve and the spindle
extension.
3. Close the shut-off valves clockwise with an allen
wrench (8 mm).
4. Remove the thermostatic element, clean filters
and lubricate the seals.
5. Reassemble in reverse order and calibrate
unit.
Calibrating Thermostat
1. If the temperature reading is different to the
showering temperature, turn the thermostat
handle until a 40°C reading is shown on your
thermometer (fig.1).
2. Undo the screw and pull off the handle (fig.2).
3. Rotate the handle so the button is positioned at
12 o clock and re-fit onto the spindle. (fig.3)
12
1
2
3
40°