Blending Tips; Frequently Asked Questions - Oster BLSTPYG1309B Manual De Instrucciones

BLENDING TIPS

Liquids
Put liquids into the jar first, unless the recipe says otherwise.
Using the jar lid filler cap / 2-ounce scoop
Do not remove the lid while in use. Food may splatter if you do. Instead, open the jar lid
filler cap / 2-ounce scoop to add smaller ingredients.
Working with Hot Foods or Liquids
WARNING: When you work with HOT FOODS, remove
the jar lid filler cap / 2-ounce scoop to vent steam. Tilt the
lid away from you partially covering the opening. Keep
hands and other exposed skin away from the lid opening to
prevent possible burns.
When you work with HOT LIQUIDS, remove the jar lid
filler cap / 2-ounce scoop and start at a low speed, and
then gradually increase to a faster speed. Do
not add liquid over the 4-cup level. Always keep
hands away from steam.
Ingredients Quantities
Use only the amount of food suggested in the recipes. If you want greater amounts,
prepare in batches. Using larger amounts may overload and strain the motor. You might
also get different results from those described.

FREQUENTLY ASKED QUESTIONS

Why doesn't the blender turn on?
• Make sure the base is plugged in an active power receptacle.
• Verify blinking light is active after pushing on/off button (
• If your blender has a touch screen, be sure to press the on/off button (
second.
How can I prevent liquids from leaking out?
Check to see that the sealing ring is correctly assembled in between the jar blade and the 1.5 L jar.
BLSTPYG1309B_BLSTPYG1310RBG_BLSTPYG1311NBG_BLSTPYG1312NBG_22SEM1 (LA).indd 8-9 BLSTPYG1309B_BLSTPYG1310RBG_BLSTPYG1311NBG_BLSTPYG1312NBG_22SEM1 (LA).indd 8-9
).
) for one
En gl is h- 8
U S I NG YO UR BL END - N- G O
(MODEL S WITH B LEN D- N - GO A C C ES S OR Y O N LY)
IMPORTANT: PLEASE MAKE SURE TO USE THE FOLLOWING PARTS FOR THE
BLEND-N-GO CUP:
A
B
Blend-N-Go Cup Blend-N-Go Cup
with Lid and Threaded
Cup Bottom with
Locking Lever
A. Locking Lever
B. Anti-Rotation Tabs
C. Blender Base
Ensure the locking sealing ring is fully and evenly tucked in
place and holding the blade assembly to the threaded cup
bottom. For correct assembly see (Fig. 3).
NOTE: For proper installation onto blender motor base, make
sure locking lever rotates past the anti-rotation tabs on the
Blend-N-Go cup.
WARNING: DO NOT PROCESS HOT FOODS OR LIQUIDS IN THE BLEND-N-GO CUP.
You're now ready to enjoy your blended drink!
E ngl is h- 9
C
NOTE: Threaded Cup Bottom
with Locking Lever MUST be
used with Blend-N-Go cup.
Incorrect Correct!
Fig. 3
7/25/2022 10:34:26 AM 7/25/2022 10:34:26 AM