Blending Tips - Oster BLSTMB-CT0-050 Manual De Instrucciones

Blending tips

• Always place your hand on the lid when operating the blender.
• Never fill the blending jug more than ¾ full. Process in batches if necessary.
• Put liquids into the jug first, unless the recipe says otherwise. Add more liquid if ingredients are not blending properly.
• Start at a low speed and gradually increase the speed whilst processing.
• Do not remove the lid while in use. Instead, remove the feeder cap to add smaller ingredients.
• Allow hot foods or liquids to cool slightly before processing. Place a folded dishcloth over the top of the blender and
place your hand over the cloth during processing.
• When you work with hot food, remove the feeder cap to vent steam. Tilt the lid away from you partially covering the
opening. Keep hands and other exposed skin away from the lid opening to prevent possible burns.
• When you work with hot liquids, remove the feeder cap and start at a low speed, and then gradually increase to a
faster speed. Do not add liquid over the 4 cup (1L) level. Always keep hands away from steam.
Pre-programmed functions
1. Press the On/Off button (
remain on when the motor is running.
2. Press the desired function button:
• Green/Frozen Smoothie (
• Food Chop/Salsa (
• Milkshakes ( )
The corresponding function light will come on, and remain on until the program is finished.
3. To change your selection, press the Stop (
4. When the program is finished, the motor automatically stops. You can press the Stop button at any time to cancel the
program. The On indicator light will flash, showing that the blender is ready to use.
Speed functions
Your blender has three speeds: Low, Medium and High (1, 2 and 3). You can use these functions for personal recipes or to
continue blending after a pre-programmed function is finished.
1. Press the On/Off button (
remain on when the motor is running.
2. Press the desired speed button to start blending. The corresponding speed light will come on, and remain on until you
press the Stop button.
3. Press the Stop button (
Pulse function
Use the pulse function to crush ice or chop food.
1. Press the On/Off button (
2. Press and hold the Pulse button (
3. Release the Pulse button to stop.
FUNCTIONS
) to turn the blender on. The On indicator light will flash. The light will come on, and
)
)
) button followed by another function button.
) to turn the blender on. The On indicator light will flash. The light will come on, and
) to cancel processing at any time.
). The On indicator light will flash.
). The pulse function operates only as long as the Pulse button is held down.
6