LaserLiner MultiMeter Manual De Instrucciones página 15

– Only the original measuring leads may be used. Their voltage,
category and ampere rated powers must match those of the
measuring device.
Additional information on use
Observe the technical safety regulations for working on electrical
systems, especially: 1. Safely isolating from power supply,
2. Securing to prevent system being switched on again,
3. Checking zero potential, two-pole, 4. Earthing and short-
circuiting, 5. Securing and covering adjacent live components.
Safety instructions
Dealing with electromagnetic radiation
– The measuring device complies with the provisions and limit
values for safety and electromagnetic compatibility in accordance
with the Low Voltage Directive (LVD) 2014/35/EU and the
Electromagnetic Compatibility (EMC) Directive 2014/30/EU.
– Local operating restrictions – for example, in hospitals, aircraft,
petrol stations or in the vicinity of people with pacemakers –
may apply. Electronic devices can potentially cause hazards or
interference or be subject to hazards or interference.
– Umarex GmbH & Co KG hereby declares that the electronic
device MultiMeter complies with the requirements and
other conditions of the European Low Voltage Directive
2014/35/EU (LVD) and the EMC Directive 2014/30/EU.
The complete text of the EC declaration of conformity is available
at the following internet address: https://laserliner.com
3
red
5
black
1
1 Rotary switch to set the
measuring function
2 Red input socket (+)
2
3 Black COM socket (–)
4
4 Red 10 A input socket (+)
5 LCD
6 Test prods
7 Measuring contacts:
red "+", black "–"
MultiMeter
6
EN
7
15