LaserLiner MultiMeter Manual De Instrucciones página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Do not measure currents above 2 A for longer than
10 seconds within 15 minutes. This could damage the
device or the test prods.
!
Current above 200 mA must not be measured in the
μA / mA range and currents above 10 A must not be
measured in the A range. Otherwise the corresponding
built-in fuse will trip (F 250 mA / 300 V, F 10 A / 300 V,
Ø 5 mm x 20 mm).
7
BAT. Battery charge status measurement
To measure the battery charge status, set the rotary switch to
the "BAT." position with the corresponding measuring range.
1,5 V = 1,5 V LR6 (AA) / LR03 (AAA) / LR14 (C) / LR20 (D)
1,2 V (NiMH) HR6 (AA) / HR03 (AAA) / HR14 (C) / HR20 (D)
9 V = 9,0 V 6LR61 (9V-block)
8,4 V (NiMH) HR22 (9V-block)
Then connect the measuring contacts to the battery.
300
200
20
2
200
m
2M
200
k
20k
2k
The battery voltage is shown on the display. You can read off the
battery charge status from the following scale.
Good: battery fully charged
Weak: battery is weak and will soon need replacing
Replace: battery is flat and should be replaced
Example
Battery: Alkaline 9 V
Measured voltage: 6.2 V
Battery charge status: weak
300
200
2000
μ
20m
200m
10A
BAT.
1.5V
BAT.
9V
200
MultiMeter
black
red
19
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido