Metra 99-5838CH Instrucciones De Instalación página 4

7. Unsnap the shifter trim bezel and
slightly pull it up to clear the center
console trim bezel removal.
8. Open the center console storage
compartment. Unclip the center console
trim bezel, then slide it toward the rear
of the vehicle to remove it. (Figure G)
Note: The complete center console
does not need to be removed, nor does
the Push-to-Start module need to be
disconnected.
9. Remove the plastic tray in front of the
gear shifter.
10. Using a pick tool, remove the center
plastic trim (knockout) between the
power outlet and the USB jack. (Figure H)
4
DASH DISASSEMBLY
(Figure G)
(Figure H)
(CONT.)
Ensure that the negative battery terminal
is disconnected before proceeding onto the
following (4) steps:
11. Remove the (4) 9/32" screws securing
the radio/climate control panel. Using
the panel removal tool, carefully unclip,
unplug, and remove the panel. (Figure I)
Note: The panel is thin and easily broken.
12. Remove the (4) 9/32" screws securing the
display screen, then unplug and remove
the screen. (Figure J)
13. Remove the (4) 9/32" screws securing the
radio chassis, then unplug and remove
the radio. (Figure J)
Note: The wires are short, so you may
have to reach into the dash to unplug the
connectors.
14. If the vehicle is equipped with SYNC,
remove the (3) 9/32" screws securing the
SYNC® module, then unplug and remove
the module.
Continue to Kit Preparation
(Figure I)
(Figure J)
|
386.257.1187 MetraOnline.com