Metra 99-5838CH Instrucciones De Instalación página 6

From the factory radio/climate control panel:
1. Remove (15) T-10 Torx screws securing
the plastic panel cover to the rear of the
climate control panel, and then remove.
(Figure A)
2. Remove (7) T-10 Torx screws securing the
circuit board to the climate control panel,
and then remove. (Figure B)
6
KIT PREPARATION
(Figure A)
(Figure B)
(CONT.)
3. Remove the rubber button membrane
from the back of the engine start/stop
switch panel. (Figure C)
4. Remove the engine start/stop switch
panel. (Figure D)
5. Press in on the (2) retaining tabs inside
the power outlet to remove the inner
portion, and then unsnap the outer ring
and cover. (Figure E)
Continued on the next page
(Figure C)
(Figure D)
(Figure E)
|
386.257.1187 MetraOnline.com