Troubleshooting - Scheppach HS105 Traducción Del Manual De Instrucciones Original

16. Troubleshooting

Fault
Saw blade is loose after the
motor is switched off
Motor does not start
Incorrect motor rotational
direction
Motor not supplying power,
fuse tripping
Burnt areas on the cutting
surface
Possible cause
Fixing nut not tight enough
Mains fuse blown
Extension cable defective
Connection to the motor or
switch not OK
Motor or switch faulty
Capacitor defective
Incorrect connection
Cross section of the extension
cable insufficient
Overload due to blunt saw
blade
Blunt saw blade
Incorrect saw blade
www.scheppach.com
Remedy
Tighten fixing nut, right-hand thread
Check mains fuse
Replace the extension cable
Have this checked by an electrician
Have this checked by an electrician
Have this checked by an electrician
Have an electrician transpose the wall plug
poles
see Electrical connection
Replacing the saw blade
Sharpen, replace saw blade
Replace saw blade
GB | 43