AirPro PROGRESS LIGHTING GULLIVER Manual De Instalación página 9

An additional safety support is provided to
prevent the fan from falling. Secure the safety
cable to the ceiling joist with screw and washer.
(Fig. 10)
Figure 10
Safety cable
Flat washer
Spring washer
#8 X 1-1/2 Screw
Step 4. Once the connection has been made,
the receiver inserts into the down rod hanging
bracket. The canopy comes up to cover the
receiver and bracket. (Fig. 11)
RECEIVER
ON DIP
1 2 3 4
HANGER
BRACKET
Figure 11
Figure 12
Installing the canopy:
Step 1. Align the locking slots of the canopy
(C) with the two screws (FF) in the mounting
bracket (A). Push up to engage the slots and to
lock in place. (Fig. 12)
Step 2. Rotate the metal cover (D) clockwise
to lock in the bottom of the canopy. (Fig. 12)
CANOPY
Installing metal mesh and bulbs:
Step 1. Insert the fan blades (M) onto the shaft
A
(U), install lock nut (Q) onto the fan shaft after
the blade assembly (M) is installed. (Fig. 13)
Step 2. Screw light bulbs (F) into the fixture
C
sockets. (Fig. 13)
Step 3. Align the locking slots of the metal
grill (G) with three Knurled screw (H) in the
FF
fixture (E). Push up to engage the slots and to
D
lock in place. (Fig. 13)
Figure 13
M
Q
U
E
F
G
H
6.