Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Adjust laser line (Fig . 22 & 23)
1. Mark an "X" on a piece of scrap wood.
2. Insert a small drill bit into the chuck and align
its tip to the intersection of the lines of the "X".
3. Secure the board to the table.
4. Turn on the laser and verify the laser lines
align with the "X" on the workpiece.
5. If the laser lines do not align, they need to be
adjusted:
a.
Using a Phillips screwdriver (not
included), remove the housing set
screws (M6 X12) on each of the laser
housings, and put aside the housings.
b.
Loosen the laser set screws on both sides with the provided 3 mm hex wrench.
c.
Rotate the laser adjustment knobs until the two lines intersect where the drill meets the
workpiece. DO NOT stare directly at the laser lines.
d.
Tighten the laser set screws with the provided 3 mm hex wrench.
6. Re-attach the housings and re-tighten the set screws.
24
Fig . 23
Laser set screw
Tighten
Loosen
Laser
housing
Laser
adjustment
knob
Publicidad
Tabla de contenido
Solución de problemas
