Assembly And Adjustments; Tools Needed For Assembly And Adjustment - Skil DP9505-00 Manual Del Propietário

ASSEMBLY AND ADJUSTMENTS

Tools needed for assembly and adjustment

WARNING
3 mm Hex Wrench
(supplied)
Adjustable Wrench
(not included)
Wedges
(not included)
WARNING
steps are completed .
Attach column to base (Fig . 3)
1. Set the base on the floor.
2. Place the column tube onto the base, align
the column flange holes with the base holes.
3. Install a hex head bolt (M8 x 20) in each
column support hole and tighten them
clockwise with an adjustable wrench (not
included).
Install table onto column (Fig . 4 – 7)
1. Loosen the set screw in the rack collar counterclockwise with the provided 3 mm hex
wrench and remove the collar (Fig. 4).
2. Remove the rack from the column.
3. Locate the table support lock handle. Insert it into the threaded hole at the rear of the table
support without tightening.
4. Insert the rack into the geared groove of the table support with the arrow on one end of
the rack pointing up and the teeth on the rack facing out. Make sure the worm shaft on the
inside of the table support is engaged with the teeth of the rack. The table support should sit
at the center of the rack (Fig. 5).
5. Slide the assembled parts down together onto the column. Insert the bottom edge of the
rack into the lip of the column support. HOLD IN THIS POSITION until step 6 is completed.
6. Place the collar bevel side down over the rack. Tighten the set screw clockwise with the
provided 3 mm hex wrench to hold the rack in position (Fig. 6).
16
Disconnect the plug from the power source before performing any
assembly, adjustment, or repair to avoid possible injury.
4 mm Hex Wrench
(supplied)
Phillips Screwdriver
(not included)
Combination Square
(not included)
To reduce the risk of injury, never connect plug to power source
outlet until all assembly
Chuck Key
(supplied)
Slotted Screwdriver
(not included)
Fig . 3
Tighten