General Safety Information - Wilo Port 600 Instrucciones De Instalación Y Funcionamiento

English
• Safety instructions are slightly indented and bold and always start
with a signal word.
• Danger
Serious or fatal injuries can occur!
• Warning
Serious injuries can occur!
• Caution
Injuries can occur!
• Caution (instruction without symbol)
Substantial property damage can occur. Irreparable damage is
possible!
• Safety instructions that refer to personal injury appear in black and
are always accompanied by a safety symbol. Danger, prohibition or
instruction symbols are used as safety symbols.
Example:
Danger symbol: General hazard
Danger symbol, for example, electrical current
Symbol for prohibited action, e.g. No entry!
Instruction symbol, for example, wear protective clothing
The safety symbols used conform to the generally applicable direc-
tives and regulations, such as DIN and ANSI.
• Safety instructions that only refer to material damage are printed in
grey, without safety symbols.

2.2. General safety information

• Personnel may not work alone when installing and removing the
pump chamber. A second person must always be present.
• Adequate ventilation must be ensured when working inside the
pump chamber.
• All work (assembly, dismantling, maintenance, installation) may only
be carried out without a pump installed.
• The operator must report any faults or irregularities that occur to a
line manager immediately. The end user must shut down the equip-
ment immediately if defects occur that represent a safety risk. These
include:
• Material fatigue to pump chamber body
• Failure of the safety and/or monitoring equipment installed
• Damage to electrical equipment, cables and insulation
• When welding and/or working with electronic devices, make sure
there is no risk of explosion.
• Only use lifting gear which is legally defined as such and officially
approved.
• The lifting gear must be kept safely and must be suitable for the
conditions of use (weather, hooking unit, load, etc.).
• Mobile equipment for lifting loads should be used in such a way that
it is guaranteed to remain stable during operation.
• When using mobile equipment for lifting non-guided loads, take
action to prevent tipping, shifting, sliding, etc.
38
SAFETY
WILO SE 11-2015 V05 DIN A4