GE PTS9200 Instrucciones De Instalación página 5

Installation Instructions
2 C CUTOUT FOR TWIN FLEX WALL OVEN OVER A WARMING DRAWER
NOTE: Install the oven only with specific models listed
on the label located on top of the oven.
NOTE: Additional clearances between cutouts may be
required. Check to be sure the oven supports above the
Warming Drawer location do not obstruct the required
interior depth and height.
When installing a Warming Drawer below a single,
double, or combination oven, a separate 120V, 60 HZ,
properly grounded receptacle must be installed. Refer to
installation instructions packed with the Warming Drawer
for specific installation requirements.
3 DOOR REMOVAL AND INSTALLATION INSTRUCTIONS
NOTE: Door removal is not a requirement for installation of the product but is an added convenience.
Upper Oven Door
The upper door contains many of the electronics and controls for the oven. It is recommended that the upper door
be removed only by a trained service technician.
Lower Oven Door
The lower door is very heavy. Be careful when removing and lifting the door. Do not lift the door by the handle.
To remove the door:
A. Open the oven door as far as it will go.
B. Remove hinge bracket, if equipped, from front frame
and set aside. The hinge bracket must be replaced, if
equipped, for proper door functionality when door is
reinstalled.
C. Push both hinge locks down toward the door frame to
the unlocked position. This may require a flat-blade
screwdriver. DO NOT LIFT THE DOOR BY THE
HANDLE!
D. Place hands on both sides of the door and close the
oven door to the removal position (approximately
1"–2" [2.5 cm–5.1 cm] from the closed position).
E. Lift the door up and out until the hinge arms clear the
slots. NOTE: The oven door is very heavy. Be sure
you have a firm grip before lifting the oven door off
the hinges. Use caution once the door is removed.
Do not lay the door on its handle. This could cause
dents or scratches.
31-2000374 Rev. 1
Per Warming
Drawer
Requirement
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
Hinge Bracket
Hinge Slot
Hinge Arm
Hinge Clears Slot
Anti-Tip Block
Against Rear Wall
Per Warming Drawer
Requirement
2" (5.1 cm) Min.
Hinge Unlocked Position
5