Prepare The Opening - GE PTS9200 Instrucciones De Instalación

Installation Instructions
1 REMOVE PACKAGING MATERIALS
Failure to remove packaging materials could result in damage to the appliance. Remove all packing parts from
oven, racks and heating elements. Remove protective film and labels on the outer door. Also, remove plastic on
trims and panel, all tape around the oven. Open oven door and remove literature pack and oven racks. Be sure to
place all literature, Owner's Manual, Installations, etc. in a safe place for future reference. Remove the bottom trim
from the top of the oven. It will be installed at the end of the installation process. The trim is wrapped separately
and taped to the top of the unit.

2 PREPARE THE OPENING

If the cabinet does not have a solid bottom, two braces
or runners must be installed to support the weight of
the oven. For Twin Flex Wall Ovens, the runners and
braces must support 220 lbs (99 kg).
NOTE: If marks, blemishes or the cutout opening are
visible above the installed oven, it may be necessary to
add wood shims under the runners and front trim until
the marks or opening are covered.
CAUTION
when using an oven mounted too high. The
recommended mounting height is based on
a 5 ft tall user.
2
Users may be burned
NOTE: If the cabinet does not have a front frame and
the sides are less than 3/4" (1.9 cm) thick, shim both
sides equally to establish the cutout width.
Suitable
Bracing to
Support
(54.9 cm) Over
Runners
Centerline
of Cabinet
2" x 4"
(5 cm x 10 cm)
or equivalent
runners level with
bottom of cutout
21 5/8"
31-2000374 Rev. 1