Important - GE PTS9200 Instrucciones De Instalación

Installation Instructions
9 INSTALL MOUNTING SCREWS
WARNING
Mounting screws must be used.
Failure to do so could result in the oven falling out of the
cabinet, causing serious injury.
NOTE: During oven mounting step, ensure that no
damage is done to oven gasket which lines the edge of
oven cavity.
NOTE: Before drilling the pilot holes, make sure the
oven is pushed as far back into the opening as it will go
and centered.
NOTE: If the cabinet is particle board, you must use #8
x 3/4" particle board screws. These may be purchased
at any hardware store.
A. D rill through the mounting holes of the side trim, for
the #8 screws provided.
B. S ecure the oven to cabinet with screws provided.
10 BOTTOM TRIM INSTALLATION
A. P lace the bottom metal trim under air divider, with
side flush against side trim. Do this with the unit 4"
out of the cabinet.
B. U sing two trim screws provided, secure the bottom
trim to the bottom duct asm.
31-2000374 Rev. 1
Install bottom trim with
unit 4" out of cabinet
4"
IMPORTANT: If this unit is ever removed from the
cabinet or the oven is ever pulled out for service,
pull unit out 4" and remove the bottom trim. This
will prevent damage to the trim.
Mounting Hole
Locations
(two provided)
9