Assembly/Disassembly - Vermeiren One Manual De Instrucciones

EN
NL
When the scooter does not fit in the car, it is also possible to transport the scooter according to
the following steps:
1. Disassemble the scooter (see §2.5).
2. Place all parts of the scooter in the car.
3. Attach the frame and other parts of the scooter securely to the vehicle.
2.5

Assembly/Disassembly

CAUTION
• Turn the scooter off before disassembly / assembly.
• Make sure that your fingers don't get trapped between moving parts.
The scooter can be disassembled into four main pieces without any tools: the seat, the front
frame,the rear frame, and the battery housing.
2.5.1 Assembly upon delivery
To assemble the scooter upon delivery:
1. Take all parts of the scooter out of the packaging.
2. Fold the steering column up and tighten into place (see §3.5.1).
3. Mount the shopping basket.
4. Place the seat support in the desired seat height (see §3.5.2).
5. Mount the seat (see §3.5.2) and fold the backrest up. Make sure it is securely fixed into
place.
6. Mount the armrests and tighten them into place with the star knobs (see §3.5.3).
7. Mount the battery pack.
8. To change the colour accents, pull off the coloured plates and replace with the desired
colour. A patch of Velcro holds them into place.
9. Place the freewheel lever in drive mode (see §3.4).
2.5.2 Assembly/Disassembly
To disassemble:
1. Switch the scooter off and place the scooter in driving mode with the freewheel lever.
2. Remove the seat by lifting it straight up and off of the scooter frame (see §3.5.2).
3. Remove the battery pack by lifting the pack straight up and off of the scooter.
4. Remove the shopping basket.
Risk of injury
6
2022-09
Before use
1
One