Skymsen PA-7 PRO Manual De Instrucciones página 6

disc or grid that is being used. Before opening the lid, make
sure the disc is fully stopped.
All the discs must easily fit in the traction system, with only
a little turning movement of the disc.
Any contact between the disc and the lid indicates a bad
positioning of the disc.
The procedure for putting and removing the discs is
described below:
1 - With the lid open, place the expelling plate to perfectly
fit the facets that are present in the axle.
2 - Fit the disc in axle being careful with the selected disc
blade, turning it softly in the counter clockwise position for
perfect lock.
3 - Close the lid, making sure it´s perfectly locked.
4 - To remove the disc, make the opposite process described
before.
The disc removal and placing must be done according to the
Picture 05.
4.2.2 Using a disc with a grid
The grid must fit between the expelling disc and the disc,
that must be completly clean to fir perfectly.
The grids must only be used with the shreding discs,
accoding to the Chart 06:
6
FIGURA 05
Slicer Disc E5
Expeller Disc
Dicing Cutting Option
GC8 PRO GC10 PRO
E5 5x8x8mm 5x10x10mm 5x14x14mm 5x20x20mm
E8 8x8x8mm 8x10x10mm 8x14x14mm 8x20x20mm
DISCS
E10 * 10x10x10mm 10x14x14mm 10x20x20mm
E14 *
* It´s not indicated the cut in cubes when the shrediding disc
is bigger than the cube grid.
You may find the procedure top lace or to remove the discs
and grids below:
1 - When the machine is turned off and the disc is stopped,
open the lid.
2 - Place the expelling disc being careful that it fits perfectly
the existing axle facets.
3 - Place the grid in such a way that it fits into the cavity
existing in the machine frame.
4 - Be careful with the selected disc blade, fit the disc in its
axis turning it softly in the counter clockwise position for
perfect lock.
5 - Close the lid and make sure that it is perfectly locked.
To remove the disc, make the opposite process described.
The disc removal and placing must be done according to the
Picture 06 and 07.
PICTURE 06
CHART 06
CUBE GRID
GC14 PRO GC20 PRO
* 14x14x14mm 14x20x20mm
Disc
Cube Grid
Expeller Plate
PICTURE 07
Cube Grid