Salicru TOP Serie Manual De Usuario, Instalación Y Puesta En Marcha página 23

• With the mains present at between 75 % and 125 % the SPS supplies output voltage through the stabiliser, as well
as charging the batteries.
• In the event of mains absent or incorrect (off margins) the inverter supplies Sine-wave energy from the batteries
for a limited time.
• When the mains returns or finds its corresponding margins, the charge is supplied once more from the commer-
cial mains after filtering, and also through the stabiliser.
• In addition to this, there is voltage peak protection for the telephone line (Fax, Modem, ...), through connectors RJ-11.
• The mere fact of the unit being connected to the mains means that the batteries are recharged.
• If the SPS, in any of its operating modes, is overloaded, it will effect a shutdown at the output after a few seconds
and, after a few more seconds, will automatically start supplying an output voltage again. This cycle will be
repeated sequentially until the load connected to the SPS is reduced.
• The unit has automatic detection of the input frequency, which is activated when it is connected to the mains supply.
• The SPS is supplied with "UPSMON" monitoring software and a connection cable for use between the unit and
the computer. In this way intelligent working is achieved, which gives perfect protection to the critical loads.
• The autonomy of all models may be extended optionally by adding external battery models through the connector
provided and which are identified by an "B" behind the model.
• All devices with the optional "Input polarity detector", are identified with a "P" behind the model.
5.- UNIT RECEPTION.
5.1.- Reception and unpacking.
• On receiving the unit, make sure that it has not been damaged in any way during transport, so it is best to unpack
it for a visual inspection and to make sure that its characteristics match those of the order (see the characteristics
plate adhered to the packaging). Otherwise, make all suitable claims to your supplier or, short of this, to our firm,
stating the manufacturing number of the unit and the delivery remittance references.
• Having completed the reception, it is best to pack the SPS once more until it is put into service in order to protect it
against possible mechanical knocks, dust, dirt, etc. In any case, we recommend that you do not discard the packaging.
• The packing consists of recyclable materials, therefore, if they are to be thrown away, they must be disposed of
in accordance with applicable law.
All manuals and user guides at all-guides.com
- 23 -