Char-Broil 463258622 Guía Del Producto página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Burner Flame Check
Remove cooking grates. Light burner and observe flame. If flame is very small
and burner shuts down, with the controller displaying E01, refer to "Sudden
drop or low flame" in the Troubleshooting Section.
Turning Grill Off
Press and hold the power button to turn off the burners. Unplug grill after each
use. Turn LP cylinder off by turning hand-wheel clockwise to a full stop.
Ignitor Check
Turn gas off at LP cylinder. Turn power
knob to start ignitor. "Click" should be heard and spark seen each time in the
collector box. See "Troubleshooting" if no click or spark.
Hose Check
Before each use, check to see if hoses are cut or worn or kinked. Replace
damaged hoses before using grill. Use only valve/hose/regulator specified by
manufacturer.
Storing Your Grill
Unplug grill after each use.
Clean cooking grates.
Store in dry location.
When LP cylinder is connected to grill, store outdoors in a well-ventilated space
and out of reach of children.
Cover grill if stored outdoors. Choose from a variety of grill covers offered by
Char-Broil at charbroil.com.
Store grill indoors ONLY if LP cylinder is turned off and disconnected, removed
from grill and stored outdoors.
When removing grill from storage, follow "Cleaning the Burner Assembly"
instructions before starting grill.
Window Care
Regularly clean window from accumulation of grease.
Use a nonabrasive cleaner such as one approved for use on ceramic glass cook
tops. Never use a razor blade or knife as it may damage the window.
To prevent breakage, do not operate the grill in the rain, near garden sprinklers,
swimming pool, or any source which may splash or spill water or any other
liquid on the glass.
If the window is accidentally broken, handle with gloves to protect your hands
and fingers from being cut.
Do not use grill with broken or chipped glass or with no glass.
USE AND CARE
ON. Set temperature and press
Pa ge 11
CAUTION
SPIDER ALERT!
SPIDER AND WEBS
INSIDE BURNER
Your burner might be different
If your grill is getting hard to light or the flame is weak, check and clean the venturis
and burners.
Spiders or small insects are known to create "flashback" problems by building nests
and laying eggs in the grill's venturi or burner, obstructing the flow of gas. The
back-up gas can ignite behind the control panel. This flashback can damage your
grill and cause injury. To prevent flashbacks and ensure good performance the
burner and venturi tube assembly should be removed and cleaned when ever the
grill has been idle for an extended period of time.
General Grill Cleaning
Do not mistake brown or black accumulation of grease and smoke for
paint. Interiors of gas grills are not painted at the factory (and should never
be painted). Apply a strong solution of detergent and water or use a grill
cleaner with scrub brush on insides of grill lid and bottom. Rinse and allow to
completely air dry. Do not apply a caustic grill/oven cleaner to painted surfaces.
Plastic parts: Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a concentrated grill
cleaner on plastic parts. Damage to and failure of parts can result.
Porcelain surfaces: Because of glass-like composition, most residue can be
wiped away with baking soda/water solution or specially formulated cleaner.
Use nonabrasive scouring powder for stubborn stains.
Painted surfaces: Wash with mild detergent or nonabrasive cleaner and warm
soapy water. Wipe dry with a soft nonabrasive cloth.
Stainless steel surfaces: To maintain your grill's high quality appearance, wash
with mild detergent and warm soapy water and wipe dry with a soft cloth after
each use. Baked-on grease deposits may require the use of an abrasive plastic
cleaning pad. Use only in direction of brushed finish to avoid damage. Do not
use abrasive pad on areas with graphics.
Cooking surfaces: If a bristle brush is used to clean any of the grill cooking
surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It
is NOT recommended to clean cooking surfaces while grill is hot.
To clean the controller face, wipe clean with soft, dry cloth.
C H A R B R O I L. C O M

Publicidad

Tabla de contenido
loading

Tabla de contenido