Char-Broil 463258622 Guía Del Producto página 12

Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you
have trouble igniting grill.
1.
Turn gas off at the controller and LP cylinder.
2.
Remove cooking grates and heat tent.
3.
Remove hardware securing burners.
4.
Detach electrode from burner.
5.
Carefully lift the burner up and away from valve openings.
We suggest three ways to clean the burner tubes. Use the one easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well) into a small hook.
Run the hook through each burner tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not use a brass wire
brush). Run the brush through each burner tube several times.
(C) Wear eye protection: Use an air hose to force air into the burner tube and
out the burner ports. Check each port to make sure air comes out each hole.
6.
Wire brush entire outer surface of burner to remove food residue and dirt.
7.
Clean any blocked ports with a stiff wire such as an open paper clip.
8.
Check burner for damage due to normal wear and corrosion, some holes may
become enlarged. If any large cracks or holes are found, replace burner.
VERY IMPORTANT: Burner tubes must
reengage valve openings. See illustrations
at right.
Correct burner-to-valve
engagement
9.
Attach electrode to burner.
10.
Carefully replace burner.
11.
Attach burner to brackets on firebox.
12.
Replace heat tent and cooking grates.
13.
Before cooking again on grill, perform a "Leak Test" and "Burner Flame Check".
USE AND CARE
Electrode
Pry off electrode with a flat blade screwdriver
Pa ge 12 C H A R B R O I L. C O M