Hilti NURON TE 6-22 Manual De Instrucciones página 31

9 Transport and storage of cordless tools and batteries
Transport
CAUTION
Accidental starting during transport !
▶ Always transport your products with the batteries removed!
▶ Remove the battery/batteries.
▶ Never transport batteries loose and unprotected. During transport, batteries should be protected from
excessive shock and vibration and isolated from any conductive materials or other batteries that may
come in contact with the terminals and cause a short circuit. Comply with the locally applicable
regulations for transporting batteries.
▶ Do not send batteries through the mail. Consult your shipper for instructions on how to ship undamaged
batteries.
▶ Prior to each use and before and after prolonged transport, check the product and the batteries for
damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
10 Troubleshooting
If a problem occurs, always observe the charge-status and fault indicator of the battery. See the section
headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
The control switch can't be
pressed, i.e. the switch is
locked.
The drive spindle does not
rotate.
No hammering action.
*2264935*
Possible cause
The forward / reverse switch is in
the middle position.
The battery is not fully inserted.
The forward / reverse switch is in
the middle position.
The function selector switch is not
engaged or is in the "Chiseling"
position or the "Chisel position-
ing" position .
Product too cold.
The function switch is set to
"Drilling without hammering"
2264935
Action to be taken
▶ Push the forward / reverse
switch to the right or left.
▶ Push the battery in until it
engages with an audible click.
▶ Push the forward / reverse
switch to the right or left.
▶ With the motor of the power
tool at a complete stop, set
the function selector switch to
"Drilling without hammering"
or "Hammer drilling"
▶ Bring the product into contact
with the working surface, switch
it on and allow it to idle. If
necessary, repeat the procedure
until the hammering mechanism
begins to operate.
▶ Set the function switch to
. "Hammer drilling"
.
.
English 25