Intended Use - Hilti NURON TE 6-22 Manual De Instrucciones

▶ Never use the battery or a battery-operated power tool as a striking tool.
▶ Never expose batteries to the direct rays of the sun, elevated temperature, sparking, or open flame. This
can lead to explosions.
▶ Do not touch the battery poles with your fingers, tools, jewelry, or other electrically conductive objects.
This can damage the battery and also cause material damage and personal injury.
▶ Keep batteries away from rain, moisture and liquids. Penetrating moisture can cause short circuits,
electric shock, burns, fire and explosions.
▶ Use only chargers and power tools approved for the specific battery type. Read and follow the relevant
operating instructions.
▶ Do not use or store the battery in explosive environments.
▶ If the battery is too hot to touch, it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Consult Hilti Service or read the
document entitled "Instructions on safety and use for Hilti Li-ion batteries".
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
→ page 25
Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning
the QR code at the end of these operating instructions.
3 Description
3.1 Product overview
3.2

Intended use

The product described is a cordless SDS­Plus rotary hammer drill. It is designed for drilling in steel, wood
and masonry, for hammer-action drilling in concrete and masonry, and for driving and removing screws. The
product can also be used for light chiseling work on masonry and for surface finishing on concrete.
For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
•
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
• For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
operating instructions.
3.3 Items supplied
SDS­Plus rotary hammer drill, side handle, depth gauge, grease, operating instructions.
The TE DRS-4⁄6 (01) dust removal module greatly reduces dust emissions and is available as an accessory.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
*2264935*
1
2264935
Dust cap
@
Chuck (blade holder)
;
Connection for the dust collection module
=
Function selector switch
%
Depth gauge
&
Forward/reverse switch with transport lock
(
Control switch
)
Grip
+
Battery
§
Installation opening for accessories
/
Battery release button
:
Battery status indicator
∙
Connection for the TE DRS­4⁄6 (01) dust re-
$
moval module
Side handle
£
Work-area light (LED)
|
English 19