EGO SNT2120AP Manual Del Operador página 31

2. Use needle nose pliers (not included)
to remove the spring from the hook
to release the belt tension
(Fig. 27 & 28).
3. Remove the drive belt by
slowly turning the auger pulley
counterclockwise while pulling the
belt outwards (Fig. 29).
4. Install the new drive belt by rotating
it onto the pulleys (Fig. 30).
Tips:
Rotate the new drive belt first
around the motor pulley, then the idler
pulley, and finally, around the auger pulley.
Slowly turn the auger pulley clockwise to
drive the belt inwards (Fig. 26).
5. Use needle nose pliers (not included)
to install the spring onto the hook to
tension the drive belt (Fig. 27).
6. Reinstall the drive belt cover and
secure it with the 9 Torx screws
removed in step 1 (Fig. 25).
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
27
28
29
30
Needle Nose Pliers
31