EGO SNT2120AP Manual Del Operador página 28

1. The scraper bar is located at the
bottom of the snow blower deck,
beneath the auger (Fig. 20).
2. Turn the snow blower on its side
(Fig. 21).
3. To reduce the risk of injury, wear
gloves. Remove the 5 sets of nuts,
spring washers, and bolts from the
outside and remove the 2 Torx
screws from the inside. Detach the
worn scraper bar from the snow
blower (Fig. 21).
4. Attach the new scraper bar to the
snow blower with the shiny surface
facing the inside of the deck
(Fig. 22).
5. Align the mounting holes in the
scraper bar with the holes in the
deck. Insert the 2 Torx screws into
the mounting holes from the inside,
shiny surface of the scraper bar and
tighten them (Fig. 22).
28
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
20
Scraper Bar
21
Outside Nut(x5)
Inside Screw(x2)
Scraper Bar
22 Scraper Bar
(Shiny surface facing inside)
Inside Screw(x2)
Inside Hole(x2)