EGO SNT2120AP Manual Del Operador página 20

To Start the Snow Blower
1. Ensure that the side rails are
securely locked in the unfolded,
open position.
2. Attach the battery pack(s) to
the snow blower and close the
battery cover. Refer to chapter
"ATTACHING/DETACHING BATTERY
PACK".
3. Power the snow blower ON by
depressing the safety button.
4. With the safety button depressed,
pull the bail switch upward to meet
the main handle (Fig. 11 & 11a).
5. Once the auger starts, release the
safety button and begin operation
(Fig. 12).
6. To advance forward, lift the main
handle to allow the auger assembly
to contact the ground (Fig. 13). The
auger traction will assist in moving
the snow blower forward.
NOTICE:
The tool is started by
depressing the safety button first,
followed by squeezing the bail switch. The
reverse operation will not start the tool.
NOTICE:
The snow blower may not
properly start if its battery temperature
is -4°F (-20°C) or less. If unit doesn't
start, remove the battery from the snow
blower and allow it to warm indoors for
10 minutes or longer. Reinstall the battery and try again.
20
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC
11
1
11a
1
12
13
Auger Propelled
Position
Auger Assembly
Contacting Ground
2
Bail Switch
Safety Button
2
Normal Operating
Position