6-4.Indirect Measurement - Beta 1693L Manual De Instrucciones

• The result of the area measurement is displayed in the
third line, the three previously measured values in lines 1, 2
and 3.
• Long press Function Button will switch to the wall areas
display mode, the corresponding Ceiling/floor area, Wall
areas and the Perimeter of floor are displayed in the lines 1,
2 and 3.
• Long press Function Button will switch back to the
length, width and height display.

6-4.Indirect Measurement

• Indirect measurement-determining a distance using 2
auxiliary measurements.
• e.g. when measuring heights that require the
measurement of two or three measurements as following
1.Press the Function Button until the display "
the distance to be measured flashes in the symbol.
2.Press ON/MEAS Button aim at the upper point (1) and
trigger the measurement.
3.After the first measurement the value is adopted, keep the
instrument as horizontal as possible.
4.Press ON/MEAS Button to measurement the distance
result of the horizontal point (2).
5.The result of the function is displayed in the summary line.
Laser Distance Meter
1
2
" shows,
17