Lighting; Maintenance - Gesipa AccuBird Pro AV Instrucciones De Manejo

GB
3 beeps and flashing LED lights for 10 seconds:
The battery needs to be changed soon (about 20% battery charge remaining).
6 beeps and flashing LED lights for 10 seconds after every setting sequence: Change
the battery after a few more riveting sequences in order to guarantee safe riveting sequences
(approx. 10% battery remaining).
9 beeps and flashing LED lights for 10 seconds: The next riveting sequence cannot be
reliably carried out. The blind riveting tool is switched off. Change the battery.
1.8

Lighting

The blind riveting tool is equipped with 3 LED lights to illuminate the work space. These can
be turned on by turning the black ring (F) behind the LEDs. There are 3 settings, which are
displayed by an arrow cast in the housing.
— Continuous light/torch function:
The lighting is switched on after a riveting sequence and stays on for
approx. 10 minutes. The LEDs then turn off automatically.
Zero position:
Lights switched off.
-- Work light:
Lights are switched on at the start of the riveting sequence. The LEDs stay
on for about 10 seconds and then switch off automatically.
1.9

Maintenance

The maintenance of the blind riveting tool is limited to the complete claw mechanism and the
associated wearing parts:
• Detach the battery from the riveting tool.
• Unscrew union nut and steel head sleeve and clean inside if necessary.
• Remove the compression springs (possible number of compression springs for triggering
force: 0 to 5 springs).
• Unscrew support sleeve with WAF 14 open-ended spanner.
• Using two WAF 17 open-ended spanners release jaw housing from threaded bush.
• Remove jaws, clean and oil sliding surfaces; replace if worn.
• Check jaw pusher for wear and replace if necessary.
• Reassemble the jaw mechanism in the reverse order; screw together jaw housing with
adapter; fit compression springs; tighten steel head sleeve with union nut.
• Reconnect battery to riveting tool.
22