Dry Applications; Vacuuming Of Liquids - Nilfisk CTS22 Manual De Instrucciones

Dry applications

[ NOTE ]
The supplied filters and the bag (if applicable) must be
installed correctly.
CAUTION!
Comply with the safety regulations governing the
vacuumed materials.

Vacuuming of liquids

CAUTION!
Comply with the safety regulations governing the
vacuumed materials.
CAUTION!
■ Make sure the liquid stop device is working correctly
before vacuuming liquids.
■ In case of foam, immediately stop working, turn off
the machine and empty the container.
■ Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
■ Dirty liquid vacuumed by the machine must be
considered conductive.
CAUTION!
Do not use the machine if the liquid mechanical stop is
not installed!
If it's used without the float, the machine may be
seriously damaged.
CAUTION!
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.
The machine vacuums liquids and deposits them into the
container.
When the machine vacuums liquids it must be equipped with
liquid mechanical stop.
The liquid mechanical stop requires a special container.
The liquid mechanical stop stops the vacuuming operation (the
vacuuming units remain activated) when the liquid container is
full; it is then necessary to turn off the machine and empty the
liquid container.
The machine does not switch off automatically.
7
CTS22 - CTS40 - CTT40
C313
GB