Wet And Dry Applications; Maintenance And Repairs - Nilfisk S2 B Manual De Instrucciones

S2B/S3B

Wet and dry applications

The supplied filters and the bag (if applicable) must be
installed correctly.
Comply with the safety regulations governing the
materials for which the vacuum cleaner is used.
If the version for liquids is used:
■ Make sure the liquid level sensor is working
correctly before vacuuming liquids.
■ If foam forms, turn off the vacuum cleaner
immediately and empty the container.
■ Warning: Switch off the vacuum cleaner
immediately if foam or liquid leaks out.
■
Regularly clean the liquid level limiting device
and check to make sure that there are no signs of
damage.
■
Warning: Dirty liquid vacuumed up by the vacuum
cleaner must be considered conductive.
Vacuum cleaner for liquids.
When vacuuming a mix of water and air, take care to
avoid overloading the motor of the vacuum unit.
GB
C352
[ NOTE ]
WARNING!
WARNING!
WARNING!

Maintenance and repairs

WARNING!
Disconnect the vacuum cleaner from its power
source before cleaning, servicing, replacing parts or
converting it to another version/variant, the plug must
be disconnected from the socket.
■ Carry out only the maintenance operations
described in this manual.
■ Use only original spare parts.
■
Do not modify the vacuum cleaner in any way.
Failure to comply with these instructions could
jeopardize your safety. Moreover, such action would
immediately make the EC declaration of conformity
issued with the vacuum cleaner void.
6
07/2018