Makita CL003G Manual De Instrucciones página 17

5. Wash the filters and mesh pipe in soapy water
when they are clogged with dust and dirt. Dry them out
thoroughly in the shade before use.
Fig.46
6. Reassemble the mesh filter.
i Insert the tubular sponge filter into the prefilter.
ii Insert the mesh pipe into the tubular sponge filter
and prefilter, passing the guide stoppers on top of the
mesh pipe through the guide hole on top of the prefilter.
iii Push the mesh pipe through the tubular sponge
filter and prefilter until it lock in place with a click.
1
1
5
Fig.47
► 1 . Prefilter 2. Tubular sponge filter 3. Mesh pipe
4. Guide stoppers 5. Guide hole
2
3
4
7. Attach the mesh filter back into the cyclone body
aligning the hooks on the mesh filter with the ports on
the suction outlet of the cyclone body. Turn the mesh
filter as shown in the figure until the hooks are locked
with a click. Make sure that the mesh filter is installed
securely.
1 3
Fig.48
► 1 . Mesh filter 2. Cyclone body 3. Hook 4. Port
Air channels in cyclone unit
Incoming foreign substance may block the air channels
in the cyclone unit and laden air flows. Remove any
obstacles in the air path if the suction performance is
being affected remarkably.
1. Disassemble the cyclone unit into three compo-
nents: dust case, mesh filter and cyclone body.
1
Fig.49
► 1 . Dust case 2. Mesh filter 3. Cyclone body
4. Cleaner body
17 ENGLISH
4
2
2
4
3