2-6-Wiring An Accessory - Zodiac PRO Serie Manual De Instrucciones

V -2-6-Wiring an accessory:
1/ Choose a free fuse location..
2/ Connect the power supply of your accessory to the terminal corresponding to this slot using a 6
mm female tab type terminal.
3/ If you have to add cable for the connection, use cable with a cross-section of at least 1.5 mm² that
complies with "marine" standards (UL1426 or SAE J378 or SAE J1127 or SAE J1128 or more generally
meeting ABYC and/or EC standards),
4/ Connect the earth cable of your accessory to the ground terminal strip using a Ø5 "ring terminal"
(same remark as previously for the cable),
5/ Insert an ATO type fuse with a max current of 15 A and greater than the load current of your
device.
+
Red wire
-
INSTALLATION AND CIRCUIT - Electricity
Red wire
Page 45 / 73
Red wire
Red wire
Direct wiring
Wiring with
switch
E
N
G
L
I
S
H
Issue 3