Zodiac PRO Serie Manual De Instrucciones página 127

In the water
When underway, self-bailer sleeve in raised position (2) and plug inserted in the
-
thru-hull (2)
Water draining procedure
-
INSTALLATION AND CIRCUIT - DRAINING
When stopped: self-bailer sleeve or plug in position (1), then navigate
-
in planing position (> 6 knots). Place parts back in position (2) when
the water is drained.
At anchor:
-
At a temporary mooring or in other situations where the boat
-
is unlikely to take in large amounts of WATER (heavy rain,
breaking waves), place the parts in position (1) or (2).
- Long-term or risky anchoring: self-bailer sleeve lowered (1) or
caps out (1).
WARNING
If the boat takes in large amounts of water from the outside (heavy rain,
wake, etc.) and the self-bailer sleeves are raised, or through-hull plugged,
the boat risks being submerged (swamped). The water taken on may then
accumulate in the bilge and make the boat much heavier causing it to lie
low in the water and cause serious damage to certain units such as the
engine or the electrical circuits.
Page 52 / 73
Issue 3