BH FITNESS BZ6260 Manual De Instrucciones página 10

ERROR CODES
E01 Possible cable fault
E02 Burst clash
E03 No speed sensor signal
E05 Possible motor overload
E08 Burned control board
Do not hesitate to get touch with the Technical Assistance Service if you have any
queries by phoning customer services (see last page in manual).
Connect the wire between top controller and
bottom controller well.
a.- Check motor wires.
b.- Check that the control board is not burned
(strong smell or smoke).
c.- Check that the voltage is correct.
Check the position or replace the speed
sensor.
a.- Lubricate the belt.
b.- Check that the motor is not burned.
c.- Check that the control board is not burned.
Change the control board.
10