Temperature Display; In-App Error Messages And Troubleshooting; System Settings; Maintenance - Polaris VTRX25iQ Manual Del Propietário

Page 14
3. Select a start time to begin the cleaning
cycle.
4. Select a cleaning mode. Mode selected will
determine runtime.
5. Press OK to save the schedule or Delete to
remove permanently.
6. Repeat steps 2-4 to program additional
days.
NOTE: Only one programmed cleaning cycle can be
scheduled per day.
Press BACK or DONE to leave the Edit
7.
Schedule page and return to the main
screen.
8. The next scheduled cleaning cycle will
display near the top of the main screen.

Temperature Display

The pool water temperature will be displayed
on the main app screen. Accurate temperature
may take a few minutes to display as the sensor
acclimates to the surrounding water temperature.
Temperature will only be displayed during an in-
progress cleaning cycle.
In-App Error Messages and
Troubleshooting
If an error occurs, the status bar will show a
warning symbol and: "Cleaning Interrupted".
1. Click on the warning symbol to view
troubleshooting advice on how to fix the issue.
2. Choose Clear Error if you believe you have
fixed the problem and want to re-try. Choose
OK if you want to suspend the cleaner in error
mode and work on the troubleshooting fix at a
later time.

System Settings

Access System Settings by pressing the gear icon in
the upper right hand corner of the app screen.
7

Maintenance

WARNING
To avoid electric shock and other hazards
which could result in permanent injury or
death, disconnect (unplug) the cleaner from
the power source before performing any
cleaning and maintenance.
IMPORTANT
Cleaner power cable may become tangled if
correct procedure is not followed after each
cleaning cycle.
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the middle
of the pool length (Figure 9). Only place enough cable
in the water to reach the farthest point in the pool.
cleaner
cleaner
Max
Floating Cable
Length
Figure 9. Optimal Entry Point in Pool
If tangling occurs, follow these steps:
1. Remove the cleaner from the pool using
the Lift System. When the cleaner is within
arm's reach, use the handle to remove from
Not
Recommended
caddy /
control unit
11.5ft (3.5m) Min
Distance between
the ebox and pool edge
Recommended
entry point
WARNING: Do not use
an extension cord