Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: To Recalculate SMART Cycle, go to the Set
Cleaning Mode after the initial calculation.
1.
From the Home screen or the
Control Box, press the Start button
begin cleaning.
2.
The app displays the cycle time in hours
and minutes.
To increase or decrease the cycle time
during cleaning, press the (+) and (–)
buttons.
-
Time adjusts up or down in 15 minute
increments.
-
Minimum run time is 30 minutes.
-
Maximum run time is 6 hours.
-
The control box displays the same
countdown and cycle setting as the app.
3.
Press
to interrupt and cancel an in-
progress cleaning cycle.
NOTE: At the beginning of each cleaning cycle, the robot
confirms your pool parameters (approximately 10
minutes). During this time, the cleaner does not
climb to the waterline.
Set Cleaning Mode
From the main screen, select Cleaning
1.
Mode to view options.
2.
Choose from available cleaning mode.
3.
In Custom mode (if applicable), select the
cleaning surface and cleaning intensity
from the on-screen icons.
Remote Control
Use your mobile device as a remote control.
IMPORTANT:
Only use Remote Control when in view of
the cleaner.
1.
From the main screen, select the Remote
tab.
NOTE: When in remote control mode, the control box
displays:
2.
You can direct the cleaner using the
remote control or use the spot clean
feature to help pick up debris.
3.
To use "Spot Clean" drive the cleaner near
where debris has collected and initiate
"Spot Clean". The Cleaner will perform a
to
short cleaning pattern to remove debris in
that area.
NOTE: If you experience significant delays between the
app command and cleaner response, you may
have a weak Wi-Fi signal or other connectivity
challenges that interfere with the immediacy of
the remote control functions.
Lift System
The Lift System is designed to assist in retrieving
the robot from the pool. Lift System can be activated
at any time during or after a cleaning cycle.
IMPORTANT:
Only use Lift System when in view of the
cleaner.
1.
From the main screen, select
System to enter automated procedure.
2.
Use the left and right arrow icons to rotate
the cleaner to face the wall of your choice.
Press the Lift System icon to drive the
3.
cleaner up the wall it is facing. The cleaner
will wait at the water line to be retrieved.
NOTE: To stop the procedure at any time, press and release
the button again.
4.
When in reach, grab the cleaner handle
and begin to pull cleaner out of the water.
The cleaner will quickly expel water to
allow for lighter, easier removal.
NOTE: Never lift the cleaner out of the pool by the floating
cable.
Program or Cancel Cleaning
Schedules
It is still recommended to remove and clean the
filter canister after every cleaning cycle.
1.
Tap the area titled Next Cleaning or
go to System Settings
Schedules.
To program a schedule, select the day of
2.
the week.
Page 13
Lift
and choose
Publicidad
Tabla de contenido
Solución de problemas
