Publicidad
4
INSTALL THE SCREWS.
Using the Torx wrench,
install 2 screws to secure
each Landing Pad. Tighten
completely to 3.5 Nm.
TIP: Tilting the Landing Pad
slightly can help to align the
screw with the hole.
5
Continue with
your SkyLine or
Control Towers
installation.
READ THESE WARNINGS!
• Make sure your SkyLine™ or Control
Towers™ with bars installed seat
completely with Landing Pad™. If they
do not seat properly, repeat step 4.
• Be sure all hardware is secured
according to the instructions. Failure to
perform safety checks before driving
away can result in property damage,
personal injury, or death.
• Attachment hardware can loosen over
time. Check and tighten if necessary,
before each use.
• To avoid damage to your vehicle's finish
remove and clean the Landing Pads and
mounting points periodically as road
sediment will accumulate over time.
Instruction #1036166B - Page 3 of 6
3.5 Nm
INSTALL THE COVERS ANYTIME
6
YOUR RACK IS NOT INSTALLED.
Using the
covers will help
keep the bases
free of debris.
DO NOT EXCEED THE
MAXIMUM WEIGHT LIMIT
To review your vehicle's specific weight limit and load
limitations for accessories, visit yakimatech.com.
For additional product support, visit yakima.com/
support or contact us directly at (888)925-4621
Monday through Friday, 7:00 AM to 4:00 PM, PST.
Remove your YAKIMA rack and accessories
before entering automatic car washes.
FOR YOUR VEHICLE.
4X
4X
4X
4X
Publicidad
