Entering Or Changing Additional Data; Entering The Fitting Traceability Code; Entering Weather Conditions - HURNER HST 300 Print+ 2.0 Manual De Instrucciones

Ocultar thumbs Ver también para HST 300 Print+ 2.0:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 59
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
(see Sect. 5.3). To say that the joint number is related to the
job, or commission, number means that the system checks,
when a commission number was entered, whether it exists
already in the internal memory. If so, it takes the highest
existing joint number for that commission, increments it by
1, and applies this new joint number to the next welding
operation in that commission.
6.3

Entering or Changing Additional Data

The additional data input screen is shown by the unit
before welding, first the screen that allows entering the
first additional data, then the one for the second additional
data. This input can be entered either using the alphanu-
meric keypad (see Info in Sect. 5.2) or by reading from a
bar code using the scanner.
For the first additional data input, the maximum length
is 20 characters. For the second data input, the maximum
length is 15 characters. Confirm your input by pressing
START/SET. The additional data will be saved to memory
and appear in the welding report. By pressing STOP/RESET,
you skip this screen without any input.
You are free to define any additional data you
see fit. For instance, you can put into these fields
information on pipe length, ditch depth, or com-
Info
ments that help with welded joint traceability.
6.4

Entering the Fitting Traceability Code

If this feature is enabled in the configuration menu, after
the fitting code was entered, another input "Fitting Code"
is required. This is the so-called "traceability code" or
"second fitting code" of the fitting.
This input is entered either from a bar code using the scan-
ner or manually using the alphanumeric keypad (see Info
in Sect. 5.2). Press the START/SET key to confirm your input.
If the code entered is not correct, a "Code Error" message
appears; check the string of numbers and correct as needed.
If the code entered is correct, it is saved to system memory
and inserted into the welding reports to be printed. By
pressing the STOP/RESET key, you skip this input.
6.5

Entering Weather Conditions

If the weather conditions feature is enabled in the system
set-up, this input is required before the fitting code can
be entered.
Use the arrow keys ñ, ò to select from "sunny," "dry,"
Version September 2022
HÜRNER HST 300 Print + 2.0 User's Manual
*** Fitting Code ***
********************
******
Display 10
****
WEATHER
****
>sunny
dry
rain
Display 11
EN
15

Publicidad

Tabla de contenido
loading

Tabla de contenido