Assembly Preparation; Assembly Instructions; Mounting The Front Panels - Pit Boss PRO Serie Manual Del Usuario

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss® Customer Care for parts.
service@pitboss-grills.com | USA: (480) 923-9630 | Canada (Toll Free): 1-877-942-2246
IMPORTANT: To ease installation, using two people is helpful (but not necessary) when assembling this unit.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed, or unless otherwise mentioned.

1. MOUNTING THE FRONT PANELS

Parts Required:
1 x Main Cabinet (#7)
1 x Cabinet Door (#8)
1 x Left Front Panel (#23)
1 x Right Front Panel (#24)
4 x Screw (#C)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly. First, lift the Cabinet Door off the hinges,
and place aside. Note illustration 1A.
• Next, flip the Main Cabinet, bottom side pointed upward, on the
cardboard. Install the Left and Right Front Panels to the bottom of
the Main Cabinet using two screws in each panel. Note illustration 1B.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

1A
8
1B
C
24
C
23
7
7