Wi-Fi Button - Devolo Magic 1 WiFi 2-1 Manual

19 Introduction
* Information about the web interface can be
found in Chapter 4 Network configuration.
** Information on improving the transmission rate
can be found in Chapter 5.1 Bandwidth optimi-
zation.
***A devolo Magic adapter switches to standby
mode after approximately 10 minutes if no active
network device (e.g. computer) is connected to the
network interface and the Wi-Fi is switched off. In
this mode, the devolo Magic adapter cannot be
accessed over the electrical wiring. As soon as the
network device (e.g. computer) connected to the
network interface is switched on again, your
devolo Magic adapter can also be accessed over
the electrical wiring again.
Check whether the adapter is connected to
the mains supply correctly and whether the
pairing operation has been carried out suc-
cessfully. For more information about this,
refer
devolo Magic 1 WiFi.
2-1
devolo Magic 1 WiFi
to
3.4 Connecting

2.3.2 Wi-Fi button

This button controls the following functions:
Wi-Fi on/off
In the factory default settings, the Wi-Fi setting is
already enabled and the Wi-Fi encryption is set to
WPA2. The default Wi-Fi key for the initial
installation of the devolo Magic 1 WiFi is the
device's Wi-Fi key.
You can find the device's unique key on the label
on the rear side of the housing. Before the networ-
king procedure, write down the WiFi key of the
devolo Magic 1 WiFi.
Fig. 4: WiFi key on the country-specific type plate
In order to connect the devolo Magic 1 WiFi with
the
your laptop, tablet or smartphone later via WiFi,
enter the noted WiFi key as the network security
key.
b
In order to switch WiFi off, press and hold the
WiFi button longer than 3 seconds.