Removing The Devolo Magic Adapter From A Plc Network - Devolo Magic 1 WiFi 2-1 Manual

3.6 Removing the devolo Magic
adapter from a PLC network
To remove a devolo Magic adapter from your net-
work and successfully restore its entire configurati-
on to the factory default settings,
1
press the reset button longer than 10 seconds.
2
Wait until the LED flashes white and then dis-
connect the adapter from the mains supply.
Keep in mind that all settings that have already
been made will be lost!
To integrate the mains supply into another net-
work, proceed as described in Chapter 3.4.2 Addi-
tion – Expanding an existing PLC network by
adding another devolo Magic 1 WiFi.
Initial use 28
2-1
devolo Magic 1 WiFi