AEG IPE84571FB Manual De Instrucciones página 21

Problem
comes on.
The control bar blinks.
comes on.
and a number come on.
You can hear a constant
beep noise.
Possible cause
The diameter of the bottom
of the cookware is incorrect
for the activated function or
function mode.
Child Safety Device or Lock
operates.
There is no cookware on the
zone or the zone is not fully
covered.
The cookware is unsuitable.
The diameter of the bottom
of the cookware is too small
for the zone.
FlexiBridge operates. One or
more sections of the function
mode which operates are
not covered by the cook‐
ware.
PowerSlide operates. Two
pots are placed on the flexi‐
ble induction cooking area.
There is an error in the hob.
The electrical connection is
incorrect.
ENGLISH
Remedy
Use cookware with a diame‐
ter applicable to the activa‐
ted function or function
mode. Use cookware with a
diameter smaller than 160
mm on a single section of
the flexible induction cooking
area. Refer to "Flexible in‐
duction cooking area".
Refer to "Daily use".
Put cookware on the zone
so that it fully covers the
cooking zone.
Use suitable cookware. Re‐
fer to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech‐
nical data".
Place the cookware on the
correct number of sections
of the function mode which
operates or change the func‐
tion mode. Refer to "Flexible
induction cooking area".
Use only one pot. Refer to
"Flexible induction cooking
area".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a
qualified electrician to check
the installation.
21