Urmet VOG5 1760/6 Manual De Instalación página 7

16.
Configuration dip-switches (SW1 / SW2 / SW 3):
– 1 of SW1, defines the operating mode of the video door phone: OFF "Hands free" (default) / ON
"Push to talk";
– 2-8 of SW1, to define the apartment number in the column;
– 1-2 of SW2, to define the station number in the apartment.
– no.1 of SW3, not used.
– no.2 of SW3, enables or disables the IR detector for gesture commands.
Refer to the system booklet for how to set the dip switches.
17.
Door to be removed in case of in-out connection with Ref. accessory 1750/50.
The video door phone is provided with a built-in hearing aid device, which only works during
video calls. Furthermore, the video door phone is equipped with two raised notches, positioned on the
sides next to the buttons
buttons by touch.
3. INSTALLATION
ATTENTION! For proper operation of the Gesture commands, do not install the device in places
where it may be exposed to direct sunlight, as the IR detector is sensitive to light.
If the video door phone Ref. 1760/6 is installed as a spare to replace a video door phone Ref. 1750/5
- / 6 - / 15 - / 16, the "Gesture commands" feature must not be activated.
• Install the flush-mounting box Mod. 503 or the flush-mounting box Ø 60 at the height indicated in the
following drawing.
The flush-mounting box Mod. 503 can be horizontally or vertically installed.
• Fix the bracket to the mounting box as indicated.
• Program the dip-switches and connect the system wires to the terminal boards.
• Fix the door phone to the bracket.
• Remove the protective film from the display.
Box Mod. 503
n° 2 M3,5 x 19 mm
provided
DS1760-001
SW1 SW2
and to help vision-impaired users locate the position of the two
Box Ø 60 mm
n° 2 M3,5 x 19 mm
countersunk screws
O N O N
=
SW3
n° 2 screws and screw
anchors included
=
7