Extreme Temperature Usage; Adjusting The Shelf (Optional); Storage Lock - Furrion ARCTIC FCR08DCGTA Serie Manual De Usuario

Extreme Temperature Usage

The normal operating temperature for this appliance is 50°F
(10°C) to 109.4°F (43°C).
The refrigerator can be used in ambient temperatures
between 109.4°F (43°C) and 125.6°F (52°C), but expect
reduced cooling performance. If the ambient temperature
exceeds 125.6°F (52°C), allow the inside of the coach to cool
down before turning on. If the ambient temperature is below
50°F (10°C), the dial control may need to be turned towards
max to operate the refrigerator. The freezer can be operated
with ambient temperatures below 32°F (0°C), but expect the
refrigerator to be frozen. Furrion recommends increasing the
ambient temperatures above 50°F (10°C) for best results.

Adjusting the Shelf (Optional)

WARNING
To avoid the possibility of child entrapment, do not remove
any shelf from the refrigerator. Shelving is intended to deter
children from play in the compartment area.
The refrigerator and freezer shelves are fixed in the
compartments from the factory. Shelving adjustment is
possible with the following Instruction:
NOTE: The instructions will walk through the freezer
compartment shelving, but apply to all shelving.
To adjust the freezer compartment shelf position:
1. Open the compartment door. (Fig. 12)
Fig. 12
2. Lever the shelf fixing screw cover using a sharp tool.
(Fig. 13)
Fig. 13
3. Loosen the fixing screw using a Phillips screwdriver.
(Fig. 14)
CCD-0005506 Rev: 03-24-22
Fig. 14
4. Repeat steps 2 and 3 to loosen the shelf fixing screw on
Fig. 15
5. Slide the shelf into an appropriate position and fix with
Fig. 16
Repeat the process for shelving in the refrigerator.

Storage Lock

Utilize the Storage Lock, provided in the accessories
package with the unit, to prop the door open during extended
storage. This will provide air flow throughout to reduce
moisture and odors.
Shelf Fixing
Screw Cover
NOTE: It is not recommended to leave the Storage Lock in
position during traveling, vibration may shake the latch loose.
1. Press the Storage Lock onto the lock bracket directly to
2. Press both sides of the Storage Lock as per the arrows
- 9 -
the other side. Pull to remove the shelf out from its original
position. (Fig. 15)
screw. (Fig. 16)
install it.
shown in Fig. 17 and pull to remove the Storage Lock.