Repairing The Mt Dry 200; How To Stop The Mt Dry 200; Disclaimers; Transport - Master Trimmers MT Dry 200 Manual De Uso Y Mantenimiento

5.4. Repairing the MT Dry 200

Only qualified staff can dismantle, repair and install new parts. In the event that the product is in warranty period,
it must only be dismantled by Master Products staff without voiding the warranty.

5.5. How to stop the MT Dry 200

The machine must be switched off, under any circumstances, when the red switch OFF on the electrical box of the
motor support is pressed. Before carrying out any maintenance work on the machine, it must be switched off and
disconnected from the mains.
The machine must be switched off and disconnected from the electricity supply immediately in case of abnormal
operation.

6. Disclaimers

Modifications to Master Products equipment are prohibited without manufacturer approval. Following unauthorised
modification, the manufacturer declines any responsibility and cancels the warranty rights for the machines to which
modifications have been made. The manufacturer will not be responsible for any failures and accidents that may result.
During the warranty period, Master Products equipment may only be disassembled and repaired by the manufactu-
rer's technical staff or its official representatives.
The operator who uses the machine must ensure that the crushed material is removed regularly, since the residues
can cause an obstruction and, therefore, a malfunction of the machine.
Master Products is characterised by the constant improvement of all its products. As a result, there may be some
differences between machine versions. If the operating characteristics or appearance of the purchased product differ
from this manual, it is necessary to contact technical support for assistance.

7. Transport

8. Electrical connection

9. Placement

The MT Dry 200 must be placed on a flat surface without irregularities, ensuring its stability and a good working posi-
tion for the user. It is only suitable for indoor use and under no circumstances should the electrical part be exposed
to water and/or humidity.
Box 39,5 x 78 x 53 cm = 22 kg // Net weight MT Dry 200 = 25 kg
230 V / 50-60 Hz single phase.
www.masterproducts.es
21