Operating The Machine; How To Use The Machine - Master Trimmers MT Dry 200 Manual De Uso Y Mantenimiento

11.

Operating the machine

The MT Dry 200 must not be modified by the user. If any task is carried out on the machine, be it, for example, main-
tenance, regulation, adjustment, etc., it is essential to comply with the safety regulations indicated in the safety section
of this manual.
11.1. Raw material conditions
The MT Dry 200 has been designed to work with all types of dry flowers between 6% and 10% humidity. Any that
are not of this nature will not be effectively processed.
11.2. Preparation of the raw material
To be able to work with the MT Dry 200, it is essential to separate the dry flowers from the branches beforehand.
This process can be done manually, or accelerated with high volume equipment such as the MB BUCKERS distribu-
ted by Master Products or any of its partners.

11.3. How to use the machine

The MT Dry 200 is designed to process the product in a horizontal position, as shown in the following image. It is
necessary to place it on a flat surface without irregularities, ensuring its stability and a good working position for
the user.
Product loading
To load the product into the equipment, it is essential that the machine is stopped and
First of all, it is necessary to remove the barrel plug, hold the machine by the front handle and lift it until the support
foot underneath the plastic tray can be unfolded. Then, leave the machine resting on the foot, as shown in the fo-
llowing image, tilting it at an angle of approximately ten degrees. Finally, the product can be loaded into the barrel.
24
¡IMPORTANT!
disconnected from the power supply.
www.masterproducts.es