Application Guidelines/Water Supply Parameters - LG GM78BGS Manual Del Propietário

global_main.book.book Page 36 Wednesday, August 3, 2022 1:23 PM
MAINTENANCE
36
NOTE
• Wrap a cloth around the front end of the water
filter cover to collect any leaking water. Hold the
water filter upright, once it is removed, to
prevent any remaining water from spilling out of
the water filter.
3
Pull the water filter downward and turn it
counterclockwise before pulling it out. Make
sure to rotate the filter down completely
before pulling it out of the manifold hole.
4
Replace with a new water filter.
• Take the new water filter out of its packing
and remove the protective cover from the o-
rings. With the water filter tabs in the
horizontal position, push the new water filter
into the manifold hole and turn it clockwise
until it stops.
5
Close the water filter cover. The cover will click
when closed correctly.
6
After the water filter is replaced, dispense
about 10 liters of water (flush for
approximately 5 minutes) to remove trapped
air and contaminants from the system.
NOTE
• Do not dispense the entire 10 liters amount
continuously. Press and release the dispenser
pad for cycles of 30 seconds ON and 60 seconds
OFF.
7
After changing the filter, press and hold the
Water Filter button for three seconds to reset
the indicator light.
CAUTION
• Failure to replace filters when required or using
non LG authorised water filters can cause the
filter cartridge to leak and result in property
damage.
Application Guidelines/Water
Supply Parameters
• Service Flow: 1,9 lpm
• Water Supply: Community or Private Well -
Potable Water
• Water Pressure: 138 - 827 kPa
• Water Temperature: 0,6 - 37,8 °C
• Capacity: 757 litres