Vaporesso LUXE QS Manual Del Usuario página 4

USER INSTRUCTIONS
1. Install & Replace the Pod
Pull out the pod from the battery and install the new one.
*If it's the first time using the device, please tear off the sticker
of the pre-installed pod.
2. Fill the E-liquid （Refer to FIGURE 1）
Snap off the mouthpiece and fill the e-liquid through the
filling slot.
*If it's the first time filling the e-liquid, please wait 5 minutes
for the coil to prime.
3. Adjust the Airflow（Refer to FIGURE 2）
The device has two different airflow options, which are
adjusted by rotating the pod direction.
When the notch of the pod is aligned with the airflow hole
of the battery, it provides a loose-MTL vaping experience.
Otherwise, it provides a tight one.
4. Start Vaping
The device is draw-activated. Inhale through the mouthpiece
and exhale to start vaping.
5. Check the Battery Level
● Green: 70%~100% (High)
● Blue: 30%~70% (Medium)
● Red: 0%~30% (Low)
6. Charging
Please use the in-box Type-C cable to charge the device. The LED
indicator will flash in red while charging and stay on green while
fully charged.
PROTECTIONS
Short-circuit / No Load / Low Resistance / High Resistance: The
device will stop working and the LED indicator will flash 5 times
in red.
Low Voltage / Over Discharging: The device will stop working
and the LED indicator will flash 3 times in red.
Overtime (8s): The device will stop working and LED indicator
will flash 3 times in current battery level color.
CAUTIONS
1. Do not leave the charging device unattended.
2. Do not drop, throw or abuse your device, which may cause
damage.
3. Please use a standard USB output charger with proper
charging current and voltage range.
ENGLISH