Installation; Assemble Ultravent - Rational UltraVent XS Manual De Instalación Original

5 | Installation

5 Installation
CAUTION
Sharp-edged panels
Risk of cuts when taking off the
UltraVent condensation hood lid.
Wear protective gloves during
installation and maintenance.

5.1 Assemble UltraVent

NOTICE
Damage to unit
When putting up the condensation
hood on the unit, all unit walls must be
closed.
NOTICE
Cable damage
Watch out for the cable routing when
putting up the condensation hood. The
cables may be squeezed and damaged
during placement.
a
The unit on which the condensation
hood is to be installed is disconnected
from the mains.
a
All unit walls are closed.
a
Front panel, side panels, seal box and
heat shield are not yet installed.
a
The required front panel with right end
stop or left end stop is ready.
a
Only necessary with Combi-Duo: Re-
move the holder from the extension of
the lower air outlet and the air vent of
the upper unit.
80.51.574_iCombi Pro-iCombi Classic_UV XS_IM_V01_EU-west
1. Loosen 6 screws on the unit cover
[ Photo 03].
2. Loosen 2 screws on the rear side
[ Photo 04].
3. Loosen the frame on the right and left
[ Photo 05].
4. Grease the seal at the bottom of the
frame [ Photo
5. Put the frame on the ventilation pipe
and attach the right part of the frame
to the unit cover with 5 screws
[ Photo 07].
6. Connect the left part of the frame to
the mounted right frame on the unit
cover [ Photo
7. Place the UltraVent on the frame. Pay
attention to the correct positioning of
the cables [ Photo
are routed through the guide provided
on the back of the frame
[ Photo 10].
8. Screw the UltraVent with 2 screws to
the frame [ Photo
9. Install the cover plate [
Note the door hinge variant of your
unit.
10. Unlock the stem [
11. Hang the stem on the UltraVent
[ Photo 14]. Lock the stem.
>>
The UltraVent is installed on the
CombiMaster Plus unit [
06].
08].
09]. The cables
11].
Photo 12].
Photo 13].
Photo 15].
15 / 112
en