Maxi-Cosi Coral 360 Manual De Instrucciones página 66

EN
A - Carrying handle
B - XL Sun canopy (built-in)
C - Push button for carrying handle
adjustment (L+R)
D - Stroller release buttons (L+R)
E - Belt hooks for lap part of belt (L+R)
F - Soft carrier release buttons + locking
indicators (L+R)
G - Safety shell
H - Soft carrier
H1 - Cover
H2 - Baby-hugg inlay
H3 - Shoulder belts with removable belt pads
H4 - Crotch strap with belt buckle & removable
crotch pad
H5 - Harness adjuster button
H6 - Soft carrier locking axle
H7 - Belt tensioner strap
H8 - Retractable soft carrier handles (L+R)
I - Soft carrier locking hooks (L+R)
J1 - Belt hook for shoulder part of belt
J2 - Instruction manual storage
J3 - Mounting bars for base
SAFETY
The car seat is developed for an intensive use of
approximately 6 years.
Coral 360 car use
• The car seat can be rotated by installing it on the
Maxi-Cosi FamilyFix 360 rotative base. It helps you to
get your child in and out of the vehicle easily.
• When the car safety belt is used, make sure the car
safety belt buckle runs in a straight line and stays below
the belt hook of the car seat.
• The car safety belt must be threaded tight along all
green markings. For a proper installation, check the
instruction in this manual and the sticker on the side of
the car seat.
66 Coral 360 40 cm-75cm / max. 12 kg
I
Maxi-Cosi
• Only use a forward-facing seat that is fitted with a
3-point safety belt that complies with the ECE R16
standard.
WARNING:
• Install the car seat only rearward facing in the car on a
forward facing vehicle seat.
• The car seat must always be locked in the rearward
facing position when travelling. Do NOT travel when the
car seat is rotated to a lateral (loading) position or to
any other unlocked intermediate position.
Coral 360 and your baby
• Make sure you can fit no more than one finger
between the harness and your baby (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Only use the baby-hugg inlay of the Coral 360 until
your baby exceeds the 60 cm length limit. Afterwards
remove the baby-hugg inlay from the Coral 360.
WARNING:
• Never place the car seat and/or the soft carrier on an
elevated surface (such as a table or chair).
• In order to prevent the car seat from tipping over
during carrying, check if the carrying handle is locked in
place in carrying position (A1).
• When Coral 360 is installed on a stroller, always make
sure to use approved car seat adapters and to secure
Coral 360 correctly.
Using the soft carrier
• Fold the carrying handle down and take both soft
carrier handles from the sides and hold them together
in one hand.
• Press the soft carrier release button on the side of the
safety shell in order to unlock the soft carrier.
• Lift up the soft carrier from the safety shell.
When placing the soft carrier back in the safety shell,
make sure it locks by means of an audible 'Click'.
• The soft carrier handles will automatically retract
when released.
• Put the carrying handle in the most forward position
towards the baby's legs until it locks (position A1).